Recent content by jimlkosmo

>$ bringup [SSM] state: 0600 -> 0000 [SSM] Error state is cleared. (PowerOff State) bringup [SSM] state: 0000 -> 0101 Bringup Mode #0 (0xFF) [SSM] ssmCb_OnStartingBePowOn() called. [SSM] Bringup mode : syspm_stat=00000000/00000000 [POWSEQ] PowerSeq_Setup called. [SSM] state: 0101 -> 0201...

It's the same values I posted between the nec/tokin caps. I measured the vddc, for the 1'' that the ps3 stays on before shutting down. 1.2V_RSX_VDDC is 1.290v and 1.2V_BE_VDDC is 1.110v. If i power on the ps3 repeatedly, the BE becomes kinda hot, but the RSX is barely warm to the touch.

Didn't work...still same red light flashing.

So i heated a dead nvidia 8800gts with the heatgun, after preheating it at the oven for 30' at 100C. It took 3'20'' for the gpu ic to desolder. Because the ps3 has a bigger board and heatspreaders above the ic's, i'm gonna heat it for 4' and check back for the results.

Yes i've read about the need for remarrying the blu ray. Because the system booted and acted the same as the original blu ray drive, i thought that maybe with rebug 4.86.1 this need was patched...My bad. I'll try remarrying the drive. About the reflow. I put the board inside the oven at 100C...

I have no way to reball the CPU sadly. I bought this ps3 for spare parts. I have a working ps3 with rebug cfw that has problem on loading Blu Ray discs. When i load a ps3 disc and boot the system, i get a black screen. When i connected the blue ray drive of the dead ps3, i got the same black...

RSX Nec/tokins are 3.0 Ohms, while CELL are 14.0 Ohms.

Hello, i got a CECHG with SEM-001 board, that powers up for 1 sec with green light, then the red light comes up along with the green. After that 3 beeps are heard and then the red light flashes while green goes off. I have connected to syscon and the errlog is filled up with 2 error codes...