Recent content by jmmattison

You get the error when the console first boots up? Sent from my SM-G965U using Tapatalk

Definitely not overheating, also not a power supply issue. I put a working psu and still have same symptoms. Red standby light on, press power, get beep, green light for 2 to 3 sec, green changes to red, followed by 3 beeps then flashing red. Sent from my SM-G965U using Tapatalk

The fan does turn on for a couple seconds, but it is not ramping to jet mode. Sent from my SM-G965U using Tapatalk

So I have replaced the first 2 nec tokens with 8 caps and managed to get rid of the yellow in the ylod. No it goes from red to green then red then a flashing red. Should I continue replacing caps? Sent from my SM-G965U using Tapatalk

Yes, there is always a chance of getting a ban when signing into psn. Sent from my SM-G965U using Tapatalk

That's impressive!! I have a cecha in same condition as you describe! I'm hoping to replace tokens and bring it back to life! Sent from my SM-G965U using Tapatalk

I was wondering if any of the slim consoles have caps that could be used on a fat console mobo? I'm getting impatient waiting for my new caps to arrive! TIA! Sent from my SM-G965U using Tapatalk

Ok, I will give it a shot! Thanks for your help!!! Sent from my SAMSUNG-SM-N920A using Tapatalk

Yes, I am hoping to get a chance to today! I am just a little confused about the fsm step. I am on 3.55 dg firmware. Can I use the fsm pkg to enter? And when I am in fsm do I need to do anything or just exit fsm and continue with steps? Sorry for the dumb questions I never encountered a rsod...

Update..... I successfully reflashed the original dump back to the console, took 3 more dumps and all 3 had same error as first 3 so I checked with md5 patched dump and the console booted! I did install rogero 3.55 with rsod bypass but as soon as I install rebug the ole rsod is back. I did find...

I guess i will patch one more time and if its a no go I will save it for parts![emoji23] Just want to thank everyone for the help!! Sent from my SAMSUNG-SM-N920A using Tapatalk

Ok psykosis, I soldered a wire to tristate to keep console on, flashed original dump back to console, unsoldered wire and the console stays on. So now im back to where i started! Got 2 dumps, both have data match error and this time i checked both in md5 and are identical. I also checked first...

No, unfortunately I didn't check with md5. Learned my lesson the hard way. Flashed patched dump, reassembled and when powered on it immediately powers off with no standby light. Sent from my SAMSUNG-SM-N920A using Tapatalk

So I have my flasher attached, got 3 dumps and all have error DATA CHECK MATCH. I have no idea what it means. Sent from my SAMSUNG-SM-N920A using Tapatalk

Ok, I might give it a shot. I have nothing to lose. I have tried removing nor chips before and it didn't go very well! [emoji23] Sent from my SAMSUNG-SM-N920A using Tapatalk