Recent content by Meuporg

Very clear & helpful guide. Thank you!

Congratz to the winners! Great give away!

MX4SIO

@Workz_777 Could you share a link to buy the legit version from trisaster.de for anyone trying to support such a great community project?

If I have a PS2 slim SCPH-90006 which is NTSC-J 50 Hz from Hong Kong and use MechaPwn to turn it into a DTL-H90001, would it make it run North American (NTSC) PS1/PS2 games at 60 Hz? Correct aspect ratio too? Or is PS1VModeNeg required for that?

Hi @NSC-Modz , Thank you for your help, good advises and kinds words. :smug: I was just playing Beyond Two Souls for around 2-3h and the console turned off immediately during a cut-scene. This never happened. 19 blades fan was always normal. Room temperature as usual. PS3 with enough air...

Removing all angled tantalums to put them back this way carefully is actually what was just done. To discard any "doubt of any short over there" like you say. No electrical tape because most repair vids online don't do it. I assumed it was ok but still asked about this in my first post...

Tantalums replaced like seen in the pics (based on this video of NSC). All were connected. Always 2 ohm between + and - lines... NEC/Tokin from CPU/GPU side left untouched. No high gauge wire to bridge positive to positive. Not as clean as NSC but it was done as carefully as possible. But I...

Thanks for the reply and your observations. These tantalums are legit from AVX - Solid SMD 6.3V 470uF 20% (purchased at Mouser) I've just removed them and put it back more precisely like advised (after checking all caps). All connected. Is it normal to have 2 ohm when I check the connections...

First of all I'd like to thank @Naked_Snake1995 for this surprising tuto and everyone here for helping "strangers from the same Family": PS3 Lovers. As you can see on my pic, all NEC/Tokin capacitors from that side were replaced by tantalums. Verified they were connected. All NEC/Tokin from...