Recent content by Slick_Prime

The clean up isn't that bad. I have a machine that I just pop the resin prints in and let it wash for like 5 minutes, you break away the supports, and you cure it for like 3 minutes. I also have a removable build plate which allows me to start the next set of prints before the 1st set is done...

If you already have the ender5, I recommend you dial in you settings. Get a set of calipers and keep printing calibration cubes and tweaking your e-steps till you are as accurate as possible. Another thing that may help is upgrading your extruder. The default extruder with the ender series is...

Something you could consider is printing it in a resin. If you're looking to make more in less time, a large resin printer could make multiple cases at once and take no more time than it would take to print a single case.Resin printers print the entire layer all at once, so the amount of time...

I went ahead and took a chance buying a katana 16MB at the flea market to try out. It's working great so far. The first card on it is used for FMCB only and at the press of a button I have access to my saves. I'm now looking into getting the 32MB variant. On a side note, I'm also interested in...

Has anyone tried to use the Katana 32mb memory cards with freemcboot and the MX4SIO. Having a magic gate card able to switch between 4 cards at the touch of a button would be very convenient for saving. But I don't know if there would be any problems unique to that particular card since it is...

Thanks for the reply. I ended up rolling back to BDM3 and I have no more problems. Also I was aware that the MC2SIOs were clones, but I was, unfortunately, unaware about the aliexpress models. I'm not currently having any problems with it, but I'd honestly like to be up to spec and not run cheap...

I'm having a small issue with OPL and MX4SIO. So previously I was running OPL 1629 bdm3 and when I wanted to save, I would just pull my FMCB card and insert another one. But today I've updated to OPL 1901 and now all games loaded through OPL no longer recognize a card in slot one at all. I've...