Recent content by POLMAN

the fact is that the temperature of the soldering station does not determine anything, if its power is not enough, even if you set 400 degrees, the soldering iron will not be able to heat this board even to 220, because its heat capacity is huge. this only works with an induction station of high...

40 watts is very small for such a heat-intensive board. 80-100 watts recommended. @SeanRanklin, Have this in mind

@squeept , Well, if people fixed instant YLOD by disassembling, replacing the thermal interface and collecting it, this, of course, is 100% of the readings for rebolling or searching for microcracks elsewhere. But not just assembly, it's weird. What do you think of Vram? grind the connection...

the number of people who were helped simply by replacing the tokens inexplicably contradicts the fact that broken tokens are a rare case, oddly enough) despite the fact that they basically do not have equipment, they do not provide heat on the pch, they use old tokens to knock with a knife, how...

lol, my friend, 2 point, thanks laughed. yes, you are right, the memory on the chip could hypothetically displace the balls under the compound, but I didn’t see any of them, the compound was applied hermetically, and such problems never arise on the same chip in principle. I met this when...

How, then, can you explain the fact that the prefix stopped working after the RSX reballing? I’ve been doing rebollings not the first day, all according to the regulations, with the necessary equipment. before reballing she worked - after reballing instant YLOD

use rose's alloy, this will facilitate soldering, it melts at a temperature of 94 degrees Celsius. but you can’t solder new capacitors on it, keep in mind. you need to remove this solder with a copper braid and solder it to an ordinary tin-lead 60/40

ok, maybe I misunderstood, I'm not a native speaker, is there a video procedure? yes I know. what is this for? I wrote above exactly what the problem is with these capacitors

so what's the point in such a procedure? flux plus efd-412a or nc-559 or kingbo rma-218. halogen spotlight, heat gun on top. This leads to deformations of the board and creates increased temperature stress on the chip, there is a risk of disabling it. This is the minimum necessary to restore...

rofl, what you can’t do for reballing without special equipment. this is a very funny friend

Hello everyone, friends! I came across a good challenge to read the entire 93-page topic in a couple of days. Finally, after reading, I may be able to uncover the mystery of the malfunction of PlayStation 3. You guys are all right at the same time, and no, including @skueept. These capacitors...