[Actually Nevermind] About soldering on the backside (Just in case!)

[WheatyPPC]

i've screwed up my PS3's fan connector and the solder pads were also screwed.. And so, before i screw something else up, i wanna know if soldering wires to these blobs(on the backside of the fan connector thingy) and then to the connector's pins would be fine? as long as i manage to fit them somehow?
If not, what should I do?
(The solder pads are covered in molten cellophane since i've forgotten to peel a piece of tape before doing whatever i did)
I have a JTP-001, just in case..

 

[vithor_VIL]

Well technically I think shouldn't be any problem, but I think it would be better if solder another pad or a replacement something like this

 

[WheatyPPC]

Well technically I think shouldn't be any problem, but I think it would be better if solder another pad or a replacement something like this

Wow, I never knew that was a thing! ...Though the sad fact is that my mum threw it awway, Haha.... Oh well, I have nothing I can do but weep..